A20B-8100-0136 Fanuc 21i A Motherboard PMC-SA5

Buy online your Fanuc 21i motherboard from CNC Fanuc series Fanuc 21i Model A PMC-SA5 reference FANUC A20B-8100-0136 for sale online on CNC-Shopping website. This Fanuc mainboard series FANUC 21i A is ready to install on your CNC Machine Tools fitted with a CNC 21i-A (21i-MA, 21i-TA). This Fanuc master board reference FANUC A20B-8100-0136 will fitt on your Fanuc yellow backplane, on the rear side of your LCD/MDI Unit. When you will have installed your Fanuc 21i-A Master board, you will be able to put back your Fanuc control video card, Fanuc CPU card, your Servo card and also your other Fanuc SMD modules (ROM, SRAM/DRAM modules). This Fanuc 21i A master board A20B-8100-0136 is tested on 21i test rigs and comes with a full warranty.

Before starting to replace your FANUC 21i motherboard A20B-8100-0136, CPU card, or boot software, make a backup copy of SRAM data. After replacement, re-enter the SRAM data. For SRAM data in the i series, an ECC check has superseded a parity check in the following editions of the motherboard and boot software. If the motherboard, CPU card, or boot software is replaced with one with a different SRAM data check method, and an SRAM data mismatch occurs, a parity alarm or ECC alarm may occur when the power is switched on, leading to loss of the SRAM data. This problem does not occur if the previous SRAM data restored from a backup copy is used after replacement or if the system is started after all memory clear. A20B-8100-0136